MICRO LUX V2 - F4 + OSD
Share this part
Parts » Flight Controllers
MICRO LUX V2 - F4 + OSD by Lumenier
The Lumenier MICRO LUX V2 F4 Flight Controller with OSD brings incredible power and performance to the micro brushless world. It uses a powerful F4 processor along with top of the line hardware. Now you can get all the performance from an F4 based flight controller in a micro size! The V2 now includes an on-board Betaflight OSD. Using an On Screen Display has never been simpler, just drag and drop in the Betaflight Configurator. This flight controller uses 20x20mm mounting holes and a low profile design allowing for smaller airframe designs than ever before. The MICRO LUX V2 comes with BetaFlight pre-installed.
The MICRO LUX supports both SBUS and PPM inputs as well as DSM/DSMX receivers with both 5v and 3.3v support.
Check out our ever growing selection of Lumenier products!
2-4S Direct Lipo input support (5-16v)
On-board BetaFlight OSD
On-board 5v/2A and 3.3v/0.2A regulators
SBUS and PPM support
RGB LED dedicated pad, Current Sensor pad and Buzzer Pad
VBAT Monitoring support
3x UART Ports
Betaflight support (Supports new DSHOT protocol)
BLHeli passthrough flashing supported by hardware
STM32F405 (2MB flash) 32-bit processor
High quality 1.6mm PCB
Micro USB connector for programming
Dimensions: 27x27x6mm (includes USB in height)
Mounting Holes: 20mm square to center of holes
1x Lumenier MICRO Lux V2 F4 Flight Controller w/ OSD
1x Set of plastic 5mm and 3mm standoffs + screws / nuts